About a year or so ago I was looking for input on how to properly connect my
Paragon I to my Kam Plus. Without going into the details, lets just say
I'm not using it yet to any extent.
Let me understand this, it's "only" 3 simple connections from the Paragon to
the
Kam Plus connector? Nothing else?????
Paragon KamPlus (per Metcalf WebPage)
RCA to PIN #
Audio OUT Pin 1 (Transmit Signal)
Audio IN Pin 6 (Receive Signal)
PTT Pin 3 (PTT)
On the Kam the following pins are not used?
Pin 2 (Ground)
Pin 4 (Key Out)
Pin 5 (FSK Out)
Pin 8 (External Carrier Detect)
If someone using a Paragon I with a KamPlus would confirm this I would be very
appreciative. If anything is in error, please correct me.
Thanks in Advance,
Roger Sellers N5EEA
email: rsellers@snds.com
rsellers@rockford.com
>>> "Steve Ellington" <n4lq%iglou.com@internet.rkd.snds.com> 03/23/98 09:28am
>>> >>>
>To interface the KAM to your Paragon you will need RCA phono plugs for the
>following connections on the rear panel:
>
> 1. Audio out
> 2. Audio in
> 3. PTT
>.... TenTec made interfacing with your TNC easy with those phono jacks...snip
>Steve Ellington
>Amateur Radio Operator N4LQ
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|