But then, "to err is HUMAN!!"
Kirby, K7EC
----- Original Message -----
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
To: "TenTec List" <TenTec@contesting.com>
Sent: 03 July, 2005 15:42
Subject: [TenTec] Orion and UPDATE mode.
I posted the original this morning
"Sun Jul 3 08:07:59 EDT 2005
Turned on Orion this AM and screen says Flash Update Mode?
After about 4 power on's over an hour, the system did load?"
I got a few replies that the recall key may have been stuck.
Don't think it was stuck, but I have a Bencher paddle with a Lucite cover.
It was very close to the rig, close enough that a small movement towaard
the rig would put pressure on whatever button it contacted.
SO, not an Orion problem at all.
WOnder how many Orion problems are also initiated by operator actions
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|