TenTec
[Top] [All Lists]

Re: [TenTec] Argo 556/Scout modules

To: tentec@contesting.com
Subject: Re: [TenTec] Argo 556/Scout modules
From: Kevin Anderson <k9iua@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 14 Jul 2007 09:13:46 -0700 (PDT)
List-post: <mailto:tentec@contesting.com>
Stuart wrote:
> Good point about the change in the metering circuit between 
> the Scout and 556.   Of course, I had overlooked that.  
> I wonder, do you remember if the board in your 556 has the 
> cut out for the finals plus heat sink?  Or is it a fully 
> rectangular board.  I had imagined they would use the same PCB
> for both models, but it does make the 556 a bit more sturdy 
> to have a rectangular board filling the unused finals space.

The 50 watt PA is its own board, which interconnects as needed. 
The space occupied by the heat sink, when removed for the 556,
is just empty space, with a thin black metal cover put on the
back.

I will have to look at the schematics further to see if there
still is overcurrent protection on the driver.

Kevin, K9IUA


-- 
-------------------------------------
Kevin Anderson, Dubuque IA USA, K9IUA
k9iua (at) yahoo (dot) com
http://postoilgeography.blogspot.com/
-------------------------------------


       
____________________________________________________________________________________
Looking for a deal? Find great prices on flights and hotels with Yahoo! 
FareChase.
http://farechase.yahoo.com/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>