To: | tentec@contesting.com |
---|---|
Subject: | Re: [TenTec] OMNI6 PLUS Alignment procedure needed |
From: | OTAKEBI@aol.com |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Sat, 29 Dec 2007 20:49:51 EST |
List-post: | <mailto:tentec@contesting.com> |
What's missing is what's missing. I know that when you send a rig to Ten Tec the technicians don't use the owners manual to do the repair and alignment why should we. And, if they have service information why do they not sell it. We don't need that to steal design. That I can do from a schematic which they provide. Dan/N4VET **************************************See AOL's top rated recipes (http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004) _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
Previous by Date: | Re: [TenTec] OMNI6 PLUS Alignment procedure needed, Bob McGraw - K4TAX |
---|---|
Next by Date: | Re: [TenTec] OMNI6 PLUS Alignment procedure needed, OTAKEBI |
Previous by Thread: | Re: [TenTec] OMNI6 PLUS Alignment procedure needed, OTAKEBI |
Next by Thread: | Re: [TenTec] OMNI6 PLUS Alignment procedure needed, OTAKEBI |
Indexes: | [Date] [Thread] [Top] [All Lists] |