TenTec
[Top] [All Lists]

Re: [TenTec] G5RV

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] G5RV
From: Ralph Matheny <mathenyr@marietta.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 31 Jan 2009 15:46:59 -0500 (EST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
The G5RV has been well reviewed by several experts.  The best review I 
know of is by VE2CV and VE3KLO, in the ARRL Antenna Compendium Vol. 4.

The long and the short of it is this:  A G5RV is a 100 foot long piece of 
wire. The best way to feed that on multiple amateur bands would be with a
multi-band matching network a selected point on the wire.  Then the 
feedline (whatever type) would be in a matched condition and losses would
be least.  An automatic antenna tuner would be ideal for such purpose, 
mounted at wherever the feedpoint is to be located.  If you can't put the
tuner up there, well-made openwire line will come close in performance,
with a proper tuner in the shack. You may have to trim the open-wire
length to get an easy tune on all bands.  But the antenna is a 100 foot 
piece of wire--with all the traits of any 100 foot piece of wire!

Adding baluns, stubs, coax, etc. as is often shown will only add loss
to the system.  That loss is what improves the match on some bands!

Pattern wise, that feedpoint mentioned above should be at the center if
you want best results at 20 meters and below.  If the higher bands are 
your favorite, then there may well be a better spot...perhaps at an end.
But that will create other problems, and probably losses.

The marvelious thing, however, is this:  Despite all that one can 
find wrong with this "100 feet of wire" there are a gizilion and a half of 
these things out there making QSO's at this very second.  It doesn't take
a great antenna to make a lot of contacts.

Ralph Matheny
K8RYU
207 Gibbons Place
Marietta Ohio  45750
mathenyr@marietta.edu








_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>