TenTec
[Top] [All Lists]

Re: [TenTec] QRPp experiment on the Omni VI

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] QRPp experiment on the Omni VI
From: Michael Goins <wmgoins@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 10 Mar 2010 16:57:35 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Yep. I do it all the time.

Michael Goins, k5wmg
Professor, Writing
University of Texas at San Antonio







On Wed, Mar 10, 2010 at 4:49 PM, Bill Rowlett <kc4atu@hotmail.com> wrote:
>
> I see no reason to think that making contacts with the power set all the way 
> down as anything strange. It is the only way some of us opperate.
>
>
>
> Bill  KC4ATU
>
>
>
>
>
>> From: K8mp@aol.com
>> Date: Wed, 10 Mar 2010 10:08:38 -0500
>> To: tentec@contesting.com
>> Subject: Re: [TenTec] QRPp experiment on the Omni VI
>>
>> Here's my story...
>>
>> Several years ago I was in a CW QSO and decided to switch to a straight
>> key in mid-stream. I turned the drive all the way down on my OMNI-6 Plus so I
>> could adjust the key spacing while listening to the side-tone.
>>
>> I tapped the key a few times and the guy I was in QSO with thought someone
>> was trying to break-in. Turns out I was S-5 on his receiver and another
>> station who was reading the mail gave me an S-4.
>>
>> I had 3 watt-meters in line (the Omni 6's, the one in my tuner, and one in
>> the line to the antenna)
>> None of them registered any movement, so my output had to be in the in the
>> 100 milli-watt range.
>>
>> I still get a kick out of telling that story.
>>
>> Later, Joe
>>
>>
>>
>> In a message dated 3/10/2010 7:36:40 A.M. Eastern Standard Time,
>> jagoudie@comcast.net writes:
>>
>> Hi y'all...
>>
>> Let's have some fun with the discussion about the output of the Omni VI
>> set at minimum output. Try operating with the power control turned fully
>> down (ccw) and see what contacts are made. Post your results here!
>>
>> Other rigs are welcome to join in, as well :-) Just post the rig you are
>> using along with your "results."
>>
>> Jim, AF3Z
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _________________________________________________________________
> Hotmail: Trusted email with Microsoft’s powerful SPAM protection.
> http://clk.atdmt.com/GBL/go/201469226/direct/01/
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>