Fernando,
Thanks for the complements. However, on my Jupiter, the skirt does not
adjust. Is this a newer design? I have an older Jupiter.
James Viars
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of N2FQ
Sent: Saturday, April 10, 2010 9:28 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Jupiter Solid Aluminum Main Tuning Dial
Congrats James on a nice looking knob.
However, I like to mention that the skirt on the knob
should move independently since it's the knob drag adjustment
on both my Orion 1 and Jupiter.
Good luck. Any interest on your part for the other smaller knobs on the
rig?
73 Fernando N2FQ
James Viars wrote:
> Hello all.
>
> Name is James Viars and call is KJ4QPK. Well, hopefully the call will be
> N4EGA
> once the FCC approves it.
>
>
>
> I bought a Ten Tec Jupiter and HATE the main tuning knob. Way too light
and
> feels like a cheap piece of crap ('cause it is). So I asked my father, who
> is a retired machinist, to turn one out of solid aluminum on his lathe. It
> is a near exact replacement minus the finger grove on the face. The
rubber
> band fits over it and feels great. Has a nice heave feel at 4 solid oz and
> can spin for hours! (well not really.)
>
> So I talked to Dad and see if he would be interested in making some more.
He
> said, "yes," as long as there was plenty of interest. I am looking to sell
> these to any interested parties and would like to charge about $50
shipped.
> This particular dial does not have the finger grove, and is a little
rough,
> as I asked my father to make it as quickly as possible for me. The bought
> ones will be much better.
>
>
>
> Oh, and I think that these MIGHT fit the Omni VII and Orion / Orion II as
> well.
>
>
> If you are interested, please email me at james.viars@comcast.net and then
> mention it here so everyone has an idea too.
>
>
> You can look at the pictures here..
>
>
>
> http://s230.photobucket.com/albums/ee21/Sn1per03/
>
>
>
> If the link does not work, just email me for pictures.
>
>
> 73 de KJ4QPK
>
>
>
> James Viars
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|