| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] soldering pl259 |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 13 Apr 2010 23:17:01 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I agree... just use the largest, fattest tip they make for it. Mass... heat... that does it. =================== K8JHR =========================== On 4/12/2010 5:43 PM, Steve Miller wrote: > The Weller WLC-100 is inexpensive so far as soldering stations go and > will do the job on PL-259s just fine. I've used it outdoors with > success. You may have to turn it up all the way but it will > definitely provide the needed heat. > ____________________________________________________ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Orion II v 2.042A: Not Ready for Prime Time!, Ron Castro |
|---|---|
| Next by Date: | Re: [TenTec] soldering pl259, Richards |
| Previous by Thread: | [TenTec] soldering pl259, Steve Miller |
| Next by Thread: | Re: [TenTec] soldering pl259, Dave |
| Indexes: | [Date] [Thread] [Top] [All Lists] |