TenTec
[Top] [All Lists]

Re: [TenTec] bugs in Orion firmware 2.044A (default BW)

To: tentec@contesting.com
Subject: Re: [TenTec] bugs in Orion firmware 2.044A (default BW)
From: Rsoifer@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 18 Jun 2010 09:49:29 EDT
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Further to my last email about DSP BW resetting to a default  value, I  
think I've figured out how my O2 picks the default value.  I have it set up  so 
that USER 1 has CW settings and USER 2 has settings for SSB.  If MODE is  
set for CW (UCW, in my case), cycling the power off and on causes it to reset 
to  the BW stored in USER 1.  Similarly for SSB and USER 2.
 
73 Ray W2RS
 
 
In a message dated 6/18/2010 12:59:57 P.M. GMT Standard Time,  
Rsoifer@aol.com writes:

When I  cycle the O2 off and on, the stacking register returns to the one I 
  
had selected, but the DSP BW resets to a default value.  The BWs of  the  
other three registers do not reset.

73 Ray  W2RS


In a message dated 6/18/2010 12:26:49 P.M. GMT Standard  Time,  
BobK8IA@aol.com writes:

Nope,  that works fine  here too. I usually use Color 4 (the Default 
color), 

but in my  test I dialed in several other colors, turned the radio power  
off  
and  then back on about 60 seconds later. All was well, as each   time the 
radio  booted with the color I had selected before  shutting  down.

This thread has been puzzling to say the least.  Some of us (me  included)  
see no change of the DSP BW setting  from shut down to  power up, as it 
should 
be.  Others report  that the radio reboots with  random (default?) BW 
settings.

I  wonder if we have some sort of issue  that or upgrade sequence we 
haven't  

explored.  




73, Bob  K8IA,  President
Arizona Outlaws Contest  Club
Club Call;  N7AT
Website:  _www.arizonaoutlaws.net_   (http://www.arizonaoutlaws.net/) 





In a message  dated  6/18/2010 4:36:30 A.M. US Mountain Standard Time,   
info4mjs@yahoo.com  writes:

Is  anybody else using the  non-default display  colors?
Upon power on/off, the  default  colors always come up, not the  selected  
one.

Mike,    WA1SEO




_______________________________________________
TenTec   mailing    list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec   mailing   list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec  mailing  list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [TenTec] bugs in Orion firmware 2.044A (default BW), Rsoifer <=