When I cycle the O2 off and on, the stacking register returns to the one I
had selected, but the DSP BW resets to a default value. The BWs of the
other three registers do not reset.
73 Ray W2RS
In a message dated 6/18/2010 12:26:49 P.M. GMT Standard Time,
BobK8IA@aol.com writes:
Nope, that works fine here too. I usually use Color 4 (the Default color),
but in my test I dialed in several other colors, turned the radio power
off
and then back on about 60 seconds later. All was well, as each time the
radio booted with the color I had selected before shutting down.
This thread has been puzzling to say the least. Some of us (me included)
see no change of the DSP BW setting from shut down to power up, as it
should
be. Others report that the radio reboots with random (default?) BW
settings.
I wonder if we have some sort of issue that or upgrade sequence we haven't
explored.
73, Bob K8IA, President
Arizona Outlaws Contest Club
Club Call; N7AT
Website: _www.arizonaoutlaws.net_ (http://www.arizonaoutlaws.net/)
In a message dated 6/18/2010 4:36:30 A.M. US Mountain Standard Time,
info4mjs@yahoo.com writes:
Is anybody else using the non-default display colors?
Upon power on/off, the default colors always come up, not the selected
one.
Mike, WA1SEO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|