Re: [TenTec] Orion I Display Question

["Phil Chambley Sr." <k4dpk@comcast.net>]

Carl is right.  It's that way on the Orion II as well.

Phil C. Sr.
k4dpk
----- Original Message ----- 
From: "N4PY2" <n4py2@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, October 23, 2010 1:19 PM
Subject: Re: [TenTec] Orion I Display Question


> I think that may mean band register "c".  Try pressing a band button
> multiple times and see if it changes.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Hays, NC 28635
> www.n4py.com
>
>
> ----- Original Message ----- 
> From: "AL7CR" <al7cr@punakea.com>
> To: "Equipment Discussion of Ten-Tec" <tentec@contesting.com>
> Sent: Saturday, October 23, 2010 1:09 PM
> Subject: [TenTec] Orion I Display Question
>
>
> > I am running version 2.063Xg software.  On the A VFO display just above 
> > the
> > hundred hertz value a lower case "c" is displayed.  I can't find the
> > meaning of that in the manual.  Can someone help me out?  If it IS in the
> > manual a reference to the page and section would be helpful.
> >
> > Thanks,
> >
> > AL7CR
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec