Also you can press the A=B, hold and it will display the version as long as
you hold the button.
Rog
----- Original Message -----
From: "Richards" <jruing@ameritech.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, October 26, 2010 12:20 AM
Subject: Re: [TenTec] OMNI VII Firmware version
Press and hold the MNU button as you turn the rig on.
Read the screen info quickly and then turn the rig off.
That should tell you the version info, without doing
any changes to the setup. The info will stay on screen
for "while" - maybe until you turn the rig off (although
it may time out... I have not left mine on all that
long to know...)
Just MY take.
============================= James -K8JHR ===============
On 10/25/2010 11:58 PM, Phil Coley wrote:
Just picked up a nice pre-owned OMNI VII. How does one check the current
version of firmware installed on unit?
I've checked the manual and website and don't see any reference as to
"how". Help would be appreciated.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|