Also... if you can wiggle the bandswitch and restore the function, it
probably needs cleaning.
Mike N4NT
----- Original Message -----
From: "JOSEPH DAVIS" <iloveantennas@dishmail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, October 29, 2010 11:16 AM
Subject: Re: [TenTec] question on TT- 546
> Thanks for ur answer,will try this . jjdavis
>
> On Thu, Oct 28, 2010 at 11:03 AM, Rick - NJ0IP / DJ0IP
> <Rick@dj0ip.de>wrote:
>
>> There's something wrong in the local oscillator.
>> Check around the area where the crystal is for 80m and resolder the
>> connections.
>>
>> 73
>> Rick
>>
>> -----Original Message-----
>> From: tentec-bounces@contesting.com
>> [mailto:tentec-bounces@contesting.com]
>> On Behalf Of JOSEPH DAVIS
>> Sent: Thursday, October 28, 2010 8:58 AM
>> To: TenTec@contesting.com
>> Subject: [TenTec] question on TT- 546
>>
>> On 80 meters occasionally frequency output goes to 1.000 mhz and receiver
>> goes dead. After a while will go on again. Other freq. ranges OK. Any
>> one
>> have any ideal? Thanks jjdavis
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|