Yes, if it's not trying to transmit on two frequencies, the problem is most
likely on the BPF board. Otherwise, it's probably one of the switching
diodes.
Should have put all this in one e-mail. Got a bad head cold. Sorry.
Phil C. Sr.
k4dpk
----- Original Message -----
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
To: <tentec@contesting.com>
Sent: Saturday, November 27, 2010 7:22 PM
Subject: Re: [TenTec] omni 6+/ power issue
K6 and K7 switch 20 meters, K2 and K3 switch 10/12.
73, Jerry, K0CQ
On 11/27/2010 5:28 PM, CSM(r) Gary Huber wrote:
Wayne,
He didn't say how much to repair but I'd bet by the time you pay to ship
it
to TT, tech labor, parts, and return shipping, you'll have $150 invested.
Here is the relevant part of the message I received....
I called the phone number you sent me for Ten Tec service and they had me
mail the radio... After week or so
they returned the radio, they replaced K6&K7 #32103 low pass board ,
cleaned
and aliganed as needed.
Radio working fine....
73 es DX,
Gary - AB9M
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|