Dave,
The Orion II provides it -- frequency info comes up on MixW and HRD. I
don't have Carl's software, so someone else (Carl?) will have to say how to
configure it.
73 Ray W
In a message dated 4/21/2011 1:21:17 P.M. GMT Standard Time,
lejeuned@centurytel.net writes:
Finally got around to hooking up my Orion 2 to my Steppir controller.
Works
great with N4PY software. However, I can find no options in the Orion 2
menus to have the Orion output frequency/mode/etc to the CAT port whenever
frequency, mode or other status changes occur independent of any external
software program. I know the OMNI VI+ had this menu option.
The N4PY software polls the Orion 2 at 2 second intervals whenever the
Steppir box is checked in the N4PY setup so the Steppir gets frequency info
via a 'Y' cable. But without the N4PY software (or I suppose any other
logging or control software) but without it looks you are out of luck
attempting to control the Steppir. Am I missing something in the Orion
setup?
Dave WN5V
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|