Have you perchance considered ordering a kit of PTO rebuild parts from
Ten-Tec and overhauling the poor PTO?
73, Mike N4NT
----- Original Message -----
From: "Hulett, Russell" <rhulett1@consolidated.net>
To: <TenTec@contesting.com>
Sent: Wednesday, November 16, 2011 6:20 PM
Subject: [TenTec] Omni D PTO Swap
> If I remove the entire PTO assembly from one Omni D and install in
> another, are there any adjustments needed other than the L1, L2, & L3
> adjustments on the PTO to set the oscillator endpoints and linearity? I
> have one rig with a smooth PTO but numerous "issues" otherwise, another
> with poor PTO but no "issues" otherwise.
>
> Thanks in advance & 73, Curt KB5JO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|