Re: [TenTec] Orion s-meter calibration

[Tom Berry <tberry1@triad.rr.com>]

Let me see if I understand this function.  I would select an S meter 
value (say S9) then change the digital count so that the S meter reads 
S9.   Is that correct?
73 Tom AA4VV



On 12/31/2011 3:48 PM, Barry N1EU wrote:
> Thanks - it's uncharted territory in there but I think I managed to
> improve things.  I was careful to record the original values before
> mucking around.
>
> 73, Barry N1EU
>
> On Sat, Dec 31, 2011 at 7:18 PM, AL7CR<al7cr@punakea.com>  wrote:
> > Go to the RX menu and press the 15m band select key.  This will bring up
> > a screen that allows you set the S meter in digital counts.
> >
> > AL7CR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec