TenTec
[Top] [All Lists]

Re: [TenTec] Delta II rig control information

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Delta II rig control information
From: "Kris Merschrod" <Kris@merschrod.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 24 Jun 2012 21:44:33 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Carl,  now I am sure that you are the person who gave the reference for the 
cables - and many thanks for the addresses and the software - we are in 
business again!

73,

Kris  KM2KM
----- Original Message ----- 
From: "Carl Moreschi" <n4py2@earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, June 24, 2012 9:13 PM
Subject: Re: [TenTec] Delta II rig control information


> The Delta II has an Icom CIV interface in it.  So it takes an Icom
> logging program to work with it.  You must know the CIV address of the
> Delta II and the correct baud rate to hook it up.  There are CIV-to USB
> converters available with an internet search that will allow you to hook
> it up to your computer.
>
> I just searched the internet and the baud rate is 1200 baud and the CIV
> address is 40h.  My N4PY Icom program should work with this.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
> On 6/24/2012 8:43 PM, Kris Merschrod wrote:
>> Steve,
>>
>> Tank you for bringing this up.  A couple of months ago teher was a thread
>> here about the right cable - I immediately picked up one cable and then 
>> was
>> distracted.  I haven't the foggiest idea but will be anxious to see the
>> answers too.
>>
>> Kris KM2KM
>> ----- Original Message -----
>> From: "Steve Weber"<kd9bo@mac.com>
>> To:<TenTec@contesting.com>
>> Sent: Sunday, June 24, 2012 7:35 PM
>> Subject: [TenTec] Delta II rig control information
>>
>>
>>> Hi  Has anyone out there connected the Delta II to a computer for logger
>>> and rig control use?
>>> I remember reading somewhere that the settings for an ICOM something or
>>> other work with this rig. Any help would be greatly appreciated.
>>> I've never done this with any rig, so please be gentle - It's my first
>>> time...
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>