Good afternoon all,
I've got a Ten-Tec Paragon (with matching 962 power supply) that is
having a problem and I'm hoping there is an easy fix that doesn't
require a trip back to the factory for repair.
Here's what happens - when I turn it out, all of the LED indicators
light up for a split second and then it turns off. The power LED on the
power supply goes off at the same time.
I disconnected the power supply, jumpered the two center pins, and its
putting out a nice 13.80 volts. Even under a 15 amp load (the highest
my electronic load will do!) its still putting out 13.3 volts.
Depressing the reset button does nothing.
Thoughts?
thanks much and 73,
ben, kd5byb
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|