Well after further examination this is NOT where I need to be - hi. It looks
like that is the locking crystal for all the "logic" - duh!
More serious examination is in order!
73,
Rick
VE7TK
Website: http://www.ve7tk.com
>________________________________
> From: Rick W <ve7tk@yahoo.ca>
>To: Ten-Tec Reflector <tentec@contesting.com>
>Sent: Thursday, December 27, 2012 4:45:03 PM
>Subject: Omni VI Frequency Adjustment
>
>
>I have recently acquired and Omni VI. The rig has seen little use in the last
>10 years but it is working VERY well with a minor exception. The rig is
>slightly off frequency (about 150 Hz) - even after a significant warm-up.
>
>
>Looking at the schematic, I have found the crystal oven on the Logic Board
>(81606). It looks like the crystal frequency can be tweaked with C31. This
>is an early O-6 and it has the crystal oven.
>
>
>Other than C31, are there any other adjustments I should be considering?
>
>
>Thanks.
>
>73,
>Rick
>VE7TK
>
>Website: http://www.ve7tk.com
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|