Rick,
I don't have that firmware. But I do not believe changing the FW will
fix the problem. I believe that problem comes and goes with temperature
variations.
The fix is to get a filter to connect to the output of the Orion between
the Orion and Acom. I researched this last year and found a filter.
But I sold my Acom 1000 and now use a different amp. So that fixed it
for me.
I think Barry, N1EU, has the info on the filter.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 1/24/2017 9:50 AM, rick@dj0ip.de wrote:
We are trying to load firmware V3.025 onto an Orion 565.
It has been running V3.032.
The V3.032 runs OK when barefoot but when using an Acom amplifier, it causes
the ARC FAULT problem with the amp.
When the radio was running V3.025 in the past years, it worked OK.
We would like to put the old firmware back onto the radio.
We have downloaded the specific firmware from the RKR site
(http://www.rkrdesignsllc.com/support/product-documentation/product-document
ation/ten-tec-565-orion/ ) but it does not run.
Other (older versions) downloaded there run OK but that specific version
seems to be corrupt.
Does anyone have this firmware or know of another site where we can download
it?
TNX
73
Rick, DJ0IP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|