TenTec
[Top] [All Lists]

Re: [TenTec] Need Orion I Firmware

To: n4py3@earthlink.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Need Orion I Firmware
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 24 Jan 2017 10:16:46 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I believe the problem is specific to the Acom 2000A but not 100% sure that
Acom amplifier models are immune.  Using a BCB high pass filter fixes the
problem.  It's due to low level, low frequency spurs in the Orion rf output
that trigger the Acom arc fault detection circuit.

I agree with Carl and don't believe that firmware versions have any effect
on this.

Barry N1EU

On Tue, Jan 24, 2017 at 10:05 AM, Carl Moreschi <n4py3@earthlink.net> wrote:

> Rick,
>
> I don't have that firmware.  But I do not believe changing the FW will fix
> the problem.  I believe that problem comes and goes with temperature
> variations.
>
> The fix is to get a filter to connect to the output of the Orion between
> the Orion and Acom.  I researched this last year and found a filter. But I
> sold my Acom 1000 and now use a different amp.  So that fixed it for me.
>
> I think Barry, N1EU,  has the info on the filter.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
>
> On 1/24/2017 9:50 AM, rick@dj0ip.de wrote:
>
>> We are trying to load firmware V3.025 onto an Orion 565.
>>
>> It has been running V3.032.
>>
>>
>>
>> The V3.032 runs OK when barefoot but when using an Acom amplifier, it
>> causes
>> the ARC FAULT problem with the amp.
>>
>>
>>
>> When the radio was running V3.025 in the past years, it worked OK.
>>
>> We would like to put the old firmware back onto the radio.
>>
>>
>>
>> We have downloaded the specific firmware from the RKR site
>>
>> (http://www.rkrdesignsllc.com/support/product-documentation/
>> product-document
>> ation/ten-tec-565-orion/ ) but it does not run.
>>
>>
>>
>> Other (older versions) downloaded there run OK but that specific version
>> seems to be corrupt.
>>
>>
>>
>> Does anyone have this firmware or know of another site where we can
>> download
>> it?
>>
>>
>>
>> TNX
>>
>>
>>
>> 73
>>
>> Rick, DJ0IP
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>