Re: [TenTec] 962 power supply {was 961 PWR Supply}

[Curt Gamble <W0ALC@MINDSPRING.COM>]

Radio Shack in Derby Kansas (Wichita) is still viable and carries lots 
of stock,  plus lots of Ham gear.
Phone # 316 788 4225    Mgr is Mark Brecheisen  KBØMOF

73,  Curt  WØALC  in CO


On 6/27/2017 12:29 PM, Joe Papworth via TenTec wrote:
> PS- Radio Shack used to stock the 25 amp version in their stores. Some of them 
> may still have it.
>
> Sent from AOL Mobile Mail
>
>
> -----Original Message-----
> From: Joe Papworth via TenTec <tentec@contesting.com>
> To: tentec <tentec@contesting.com>
> Cc: k8mp <k8mp@aol.com>
> Sent: Tue, Jun 27, 2017 02:09 PM
> Subject: Re: [TenTec] 962 power supply {was 961 PWR Supply}
>
>
> It was a long time ago but it was probably the only place I found room. Or it 
> could have been an existing screw or stud.
> That bridge is toast.
>
> Sent from AOL Mobile Mail
>
>
> -----Original Message-----
> From: Robert S Jenkins <<a href="mailto:qrp@kg4kgl.net";>qrp@kg4kgl.net</a>>
> To: Discussion of Ten-Tec Equipment <<a 
> href="mailto:tentec@contesting.com";>tentec@contesting.com</a>>
> Sent: Tue, Jun 27, 2017 01:31 PM
> Subject: Re: [TenTec] 962 power supply {was 961 PWR Supply}
>
>
> Those values were with the bridge completely out of the circuit.
>
> Why did you mount it on the back of the front panel?
>
> Tnx,
>
> Robert
> KG4KGL
>
> > On Jun 27, 2017, at 13:25, Joe Papworth via TenTec <<a href="<a 
> > href="mailto:tentec@contesting.com";>tentec@contesting.com</a?">mailto:tentec@contesting.com";>tentec@contesting.com</a</a>>>
> >  wrote:
> >
> > If the bridge is still in the circuit, that .2 ohm reading is the secondary 
> > winding of the transformer.
> > If it does end up being the bridge, I recommend you remotely mount the new one 
> > somewhere. I put mine on the back side of the front panel. Use BIG wire. (At 
> > least 12 gauge)
> > And use heat sink grease.
> >
> > Sent from AOL Mobile Mail
> _______________________________________________
> TenTec mailing list
> <a href="<a 
> href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a?">mailto:TenTec@contesting.com";>TenTec@contesting.com</a</a>>
> <a href="<a href="http://lists.contesting.com/mailman/listinfo/tentec"; 
> target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>" target="_blank"><a 
> href="http://lists.contesting.com/mailman/listinfo/tentec</a" target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a</a>>
> _______________________________________________
> TenTec mailing list
> <a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
> <a href="http://lists.contesting.com/mailman/listinfo/tentec"; 
> target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec