Might check www.normsfab.com
Matt
W5LL
----- Original Message -----
From: "Hank Phillips" <aa4hp@titustek.com>
To: <towertalk@contesting.com>
Sent: Thursday, June 02, 2005 7:41 PM
Subject: [TowerTalk] Custom Torque Arms For Rohn 55G
>I seem to remember a post quite a while ago about custom torque arms for
> Rohn tower, but can't seem to locate it.
>
> I am looking for torque arms for Rohn 55G that has the torque arm guy
> points offset 60 degrees from the tower legs so you can guy back to the
> same anchors that the Rohn guy brackets are guyed to.
>
> I want to use this on a tower which is already up and guyed using the Rohn
> guy brackets, but appears in need of a bit of additional strength under
> the
> two antennas on top.
>
> The quotes from local metal fabricators are pretty pricey for a one of a
> kind. Anybody know of a place that does or has this already?
>
> Thanks and 73,
>
> Hank
> AA4HP
>
>
> _______________________________________________
>
> See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
> Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with
> any questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|