OOPS, I should NOT have said "impact wrench." "Hammer drill" would be a
better term. I doubt that an impact wrench would be a lot of help driving a
ground rod. The ancient one I use doesn't have the hammer only option but
still works just fine. It just "decorates" the tops of the ground rods as
it drives them in.
73 - JC, k0hps@amsat.org
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of Ian White GM3SEK
Sent: Saturday, June 11, 2005 1:33 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Copper pipe for ground rods?...YES
JC Smith wrote:
>Also (sorry if I'm repeating myself here) I have found that a large
>impact wrench or roto-hammer with a socket large enough to fit over the
>ground rod makes a slick driver. The rod just zips on in. Pounding
>with a sledgehammer in the same dense clay soil is serious work here.
Like JC, I've had good success with a 0.5in square socket drive adapter
for the SDS hammer drill, and the right size of socket to slip over the
end of the ground rod.
You can buy special ground rod drivers for SDS drills, but you'd need
one for each diameter of rod. If you already have an SDS drill and a
socket set, the adapter is more versatile and cheaper too.
With the SDS drill set to hammer-only, rods just fall into soft ground
or even hard clay.
In rocky ground, it's easier to make a pilot hole using a very long
drill bit. SDS bits are available in 10mm or 12mm diameter up to 1.0
metre long (0.4 or 0.5in x 39in) and they will drill through most kinds
of rock, even at full depth. Also the drilling doesn't disturb the
surrounding soil much. A slightly under-size pilot hole pretty much
guarantees that the first 1.0m of ground rod will go in very easily...
though below that level you're back to pure hammering again.
If the pilot hole works for copper and copper-plated steel rods, it
should work even better for copper tubing.
If you don't know about SDS drills, all I can say is: you're going to
want one! They really are as good as everybody says. See:
http://www.diyfaq.org.uk/powertools/sds.htm
--
73 from Ian GM3SEK
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
See: http://www.mscomputer.com for "Self Supporting Towers", "Wireless Weather
Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions
and ask for Sherman, W2FLA.
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|