Yes...
You take a piece of the same tubing cut a length about 20% of the
entire boon, (6' for a 30 ' boom). now cut a 1/4 inch wide slit out
of the length of the insert...now take hose clamps-compress
it...slide it into the two half's, center it ..remove ther hose
clamps...now sheet metal screw the assembly together.....redesign
your boom to mast bracket so it grabs at least 10 inches of the boom
on each side of center.....use a strong back that is 15% in on each
boom end..and your all set...
I've done this on all my W2PV (3" boom) monobanders, out to 44 and 56
feet. used two strong back on this length of boom..and never had a problem...
-Bill
At 12:36 AM 11/21/2006, you wrote:
>I'm considering building a long yagi for 20 meters and I see the ARRL
>antenna book recommends using 3" aluminum tubing for the boom. One
>thing I don't find is how to connect the sections together. There
>doesn't appear to be a standard tubing size which would slip either
>inside or outside the 3" tubing to allow clamping or riveting. Or
>maybe I just missed it.
>
>Any suggestions?
>
>Bill, W6WRT
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|