Fwiw, it takes a face-width of around 24 inches to fit completely inside a
section. I have one in an 18 inch faced tower, its motor hangs out one
side, and does a fine job of turning a TH11/402CD stack. If you have an
older one, put a bonnet on the mast to keep water out of the exposed bearing
on the top.
73, Dave, N3HE
----- Original Message -----
From: "Saad Mahaini" <n5ff@tx.rr.com>
To: <towertalk@contesting.com>
Sent: Sunday, March 04, 2007 9:19 AM
Subject: [TowerTalk] Prosistel PST61 in Triex 470
>
> Hello,
>
> Has anyone installed the Prosistel PST61 rotor in the TriEx 470 Crank up
> tower? I appreciate any info on this.
>
> 73, Saad N5FF
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|