Hey Guys,
So, I put the antenna and rotor back up yesterday. My rotor refuses to
turn. I am running about 350 feet from the controller to the rotor.
Anyone know of a way to check from the ground if the rotor is good and
possibly just the control box. I looked inside the control box and only
four wires go to the pin assembly. Can I just apply power to two of the
correct wires to see if it works?
Appreciate any help you might have.
Steve
N2MAI
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|