I should add that the 'true' Moxon that you refer to is about 3/8 by 1/8
waves. I am used to the end loaded shorter versions here: 1/4 by 1/8.
I have a fractal version that is 1/8 by 1/8 waves.
73,
Chip W1YW
In a message dated 3/20/2013 1:22:21 P.M. Eastern Daylight Time,
W1YW@aol.com writes:
Sorry Dave; the Moxon phasing is caused by the 1/8 wave separation. It is
a close-spaced 2 el Yagi.
The Hex is a Moxon with W bendbacks of the driven and parisitic.
The virtue of the Moxon is that it fits in a form factor that is about
1/4 wave by 1/8 wave, as opposed to 1/2 wave by 1/8 wave. This makes it
practical to support as wires as opposed to tubes. The Hex shrinks the long
extent a bit more.
Best,
Chip W1YW
-------------------------------------------------------------------------
In a message dated 3/20/2013 1:16:10 P.M. Eastern Daylight Time,
xdavid@cis-broadband.com writes:
Yes. A true Moxon has less forward gain (only slightly so on a proper
design) and less front-to-side than a normal yagi, but it has a really
deep notch off the back. The statement that a Moxon is nothing more
than a 2 element yagi with bent ends is simply false. There is a phasing
component that is not purely parasitic.
73,
Dave AB7E
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|