2 things
Your mast is not real 2 IN OD or become too smooth and there is not grip
where the Slipp Not make his work
move the antenna higher or lower in the mast to avoid that place where is
slipping
I install antennas using Slipp Not and what slip is the rotor not the antennas
the only problem is the PVC plate when is over tight will break
J.Hector Garcia XE2K / AD6D
Mexicali B.C DM22fp / El Centro
P.O.Box 73
El Centro CA 92244-0073
http://xe2k.net
Tweeter @XE2K
________________________________
From: dave arruzza <w1ctn@yahoo.com>
To: "towertalk@contesting.com" <towertalk@contesting.com>
Sent: Thursday, December 19, 2013 1:07 PM
Subject: [TowerTalk] Slipp-Nott
To all...
I have a Tennadyne T10 that recently has started to slip on the mast. No matter
how much I tighten the clamps slippage eventually returns and then I am off the
bearing the rotor displays.
Tennadyne markets the Slipp-Nott. Does anyone on the reflector have real world
experience using this item. Does it really work?
73
Dave
W1CTN
Radio Ansonia
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|