Towertalk
[Top] [All Lists]

Re: [TowerTalk] ROHN TOWER BOLTS UPDATE

To: Keith Dutson <kdutson@sbcglobal.net>, Tower Talk <towertalk@contesting.com>
Subject: Re: [TowerTalk] ROHN TOWER BOLTS UPDATE
From: J Chaloupka via TowerTalk <towertalk@contesting.com>
Reply-to: J Chaloupka <boltsnutspins@yahoo.com>
Date: Thu, 8 May 2014 09:11:53 -0700 (PDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
My idea, not fact.  In assembly to align the mismatch of the two members being 
bolted a tapered drift pin is used in the large hole to make for perfect 
alignment.  The smaller bolt is then inserted in it's hole and tightened.  The 
small bolt then holds the assembly in correct alignment for the large and 
necessary bolt to be inserted and be torqued to specification.  
Why not use two large bolts?  Well to contain costs and only one bolt is 
necessary and further there may not be enough metal in the tower leg to allow 
for two bolts.  (two large bolts mean bolts too close to the edge of the metal 
etc, etc.

de JIM, WD8QBQ


________________________________
 From: Keith Dutson <kdutson@sbcglobal.net>
To: Tower Talk <towertalk@contesting.com> 
Sent: Thursday, May 8, 2014 11:14 AM
Subject: Re: [TowerTalk] ROHN TOWER BOLTS UPDATE
 

I will guess the original design called for one large bolt.  Likely for
insurance/liability reasons, someone decided to add a second bolt.  It would
not need to be as strong, so a smaller (lower cost) bolt was chosen.

73, Keith NM5G

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Cal
Zethmayr
Sent: Thursday, May 08, 2014 9:16 AM
To: towertalk@contesting.com
Subject: [TowerTalk] ROHN TOWER BOLTS UPDATE
Importance: High

Thanks to everyone for the responses and the info

BUT ONE KEY UNANSWERED QUESTION?


WHY the two different bolt sizes?

Like our Club President N4CU-Bob Walker, I called Rohn in Peoria and was
transferred to CODY...  turns out he is in SALES not engineering.
He said same thing to me,"I don't know why it's just always been that way."

There is a Rohn Grandson of the founder of the company, but he is away from
the factory on a trip.

SO does anyone know the REASON FOR TWO DIFFERENT BOLT SIZES?

And is Rohn the only tower company that does this?

Cal Z
W4GMH

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>