Tnx Don,
I should have mentioned that there aren't any antennas on the mast yet, and
thrust bearings are taking the load.
I went ahead and tried it without incident.
-Mike-
>________________________________
> From: Don Moman VE6JY <ve6jy.1@gmail.com>
>To: Tower Talk <towertalk@contesting.com>
>Sent: Tuesday, May 27, 2014 6:58 PM
>Subject: Re: [TowerTalk] Tail Twister Question
>
>
>You wont damage it but it may not work, depending how sticky the solenoid
>brake system is.... the brake likely will retract but may not engage
>properly. And if you're depending on the brake to hold a yagi in a certain
>position while you are tilting it up, it may not.....
>
>73 Don
>VE6JY
>
>
>On Tue, May 27, 2014 at 11:26 PM, Mike Fahmie via TowerTalk <
>towertalk@contesting.com> wrote:
>
>> Is it safe to operate the TX2 while it is laying on its side ?
>>
>> I don't find anything in the manual EXCEPT for this step in the CHECK OUT
>> section:
>>
>> D. With the rotator sitting in the upright position
>> and connected to the control unit by the 8-
>> wire cable, plug the control unit power cord
>> into a receptacle.
>>
>>
>> That statement raised my caution flags. The rotor is mounted in the tower
>> and the tower is tilted down to horizontal. I'd like to run it briefly to
>> check things out before I hand crank it vertical.
>>
>> -Mike-
>> WA6ZTY
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
>
>>
>_______________________________________________
>
>
>
>_______________________________________________
>TowerTalk mailing list
>TowerTalk@contesting.com
>http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|