I always put a little flux on the center conductor before I crimp it, then
solder.
On Thu, Sep 5, 2019 at 10:08 PM Bert <balmemo@sympatico.ca> wrote:
> I always solder the pin, regardless!
>
> Bert VE3NR
>
>
>
> On 9/5/2019 10:22 PM, Jon Pearl - W4ABC wrote:
> > Hi Bob,
> >
> > Every site that I've visited dealing with this product shows them to
> > be crimp/solder connectors...
> >
> > https://www.amphenolrf.com/182102.html
> >
> >
> >
> > 73,
> >
> >
> > Jon Pearl - W4ABC
> >
> >
> > On 9/5/2019 12:07 PM, W3YY wrote:
> >> Julio -
> >>
> >> I use the DX Engineering Ultra-Grip 2 Crimp Connector Tool Kit, the DX
> >> Engineering RG-213 cable, and Amphenol 182102 no solder crimp connectors
> >> (both shield and pin are crimped - no soldering required). This
> >> combination
> >> has provided beautiful results for me without any problems. I will
> >> never go
> >> back to PL-259's that require solder.
> >>
> >> Amphenol UHF crimp connectors from DX Engineering are reasonably
> >> priced but
> >> can usually be found at slightly lower cost from the major electronic
> >> parts
> >> suppliers.
> >>
> >> 73, Bob - W3YY
> >>
> >
> > ---
> > This email has been checked for viruses by Avast antivirus software.
> > https://www.avast.com/antivirus
> >
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> >
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|