Fellow WL users,
Just downloaded my copy of the software and am quite impressed with it.
I am using a TS850S transceiver and when I attempt to playback a recording
(one that I created in the sound recorder) when I am in monitor mode on the
radio, I can only hear bits and pieces of my recording. Do I not have my
level set correctly for output from the soundcard?.
I do have another question regarding use of the soundcard as a DVK. I
looked at the help file but cannot understand how to create a file that will
send out the call,serial number etc...
I have created individual .wav files with each of the letter of the alphabet
and numbers.
Further, the instructions indicate that you must create a wav file with the
function key number associated with it then add a %C (C for callsign etc..)
MY question is how does one create this file? Not very familiar with DVK
and the sound files in general as you can see.
As a supplemental question, the help file also makes reference to the fact
that you can record on the fly by typing Shift+Fn and end the recording by
typing Escape. I tried this but could not get it to work.
I guess you can tell that I am also a newbie with computers?
Any detailed help on the above would be greatly appreciated. Thank you
Serge VA3SB
|