FT-450 not able to communicate using FTdx9000 model.
A FT-2000 works GREAT using FTdx9000 model.
Am getting NO RIG in window while FT-450 is hooked up.
COM4 is 4800,n,8,1
I have tried 4800,n,8,2
Have tried RTS on and off have jumpered 7-8
Tried different wait states 10ms default.
Can set freq selecting example click 7000 and mode lsb
click sets radio then NO RIG comes up after displaying freq info..
IS the statement commslot4=4 needed in the ini file if I am using a RIG
on com 4????
And where is the commslot statement supposed to be located?
In the[RIG] section.
There are 4 "slots" available for WriteLog rig interfacing. By default,
> CommSlot1 is COM1:, but you can change that by changing the number on
> the right of the equal sign. These settings are not used for RTTY or for
> packet
>
> CommSlot1=1
> CommSlot2=2
>
> In this example, the third and fourth slots are on COM7 and COM8. COM15
> is as high as is supported.
>
> CommSlot3=7
> CommSlot4=8
--
de KR4DA Bob Middleburg, FL
HK0/KR4DA J79DA FG/KR4DA
FT-2000 ser# 6J0400xx
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|