The [Cut-Numbers] section can appear anywhere in the ini file. Mine is just
after the [Configuration] section. All the ini commands, their syntax and a
short description are in the Help manual.
73,
Gary AL9A
----- Original Message -----
From: "Jerry Flanders" <jeflanders@comcast.net>
To: "Edward Taylor" <Phinehas@columbus.rr.com>
Cc: <writelog@contesting.com>
Sent: September 23, 2009 8:16 AM
Subject: Re: [WriteLog] CW number setup
> The writelog.ini file REALLY needs to come with ALL options already
> listed (and with those not wanted in the standard installation
> commented out). If they were there, it would be pretty easy for a guy
> to change the comment status to enable them. Otherwise, he often has
> to guess about proper format and make repeated attempts to discover
> how to make it work. Don't ask how I discovered this wisdom.
>
> Ed, search the help files - you might possibly discover the exact
> format for this command. I am not sure if order is important in the
> ini file - probably not. I am not sure if a [cut-number] header is
> important either. Just do what the rest of us do - guess and try.
>
> Jerry W4UK
>
> At 07:46 AM 9/23/2009, you wrote:
>>Hello to all,
>>
>>I sent a email about a week ago asking about the CW display. Gary,
>>AL9A, was kind enough to provide an answer. Thanks Gary!
>>
>>My new problem is this: when I set up the CW/RTTY/SSB Memory Setup
>>window, I type in %3 so that my sequence will be sent in a three
>>digit format. The instructions in the WriteLog Manuals say that "T"
>>will be sent for "0" (zero). However, my program sends "0" NOT
>>"T" This makes a big difference in CW contesting.
>>
>>The manual states that "if the mode is CW, the digits are translated
>>to letters according to the [Cut-Numbers] section in
>>WRITELOG.INI." When I go to the [Cut-Number] instructions of the
>>manual, it shows a table that says that 0 will be sent as 0 if "you
>>don't set up this section." The manual states that the WriteLog.ini
>>file is in ASCII and is "directly editable."
>>
>>I have not been able to discover how to set up the [Cut-Number]
>>section of the WriteLog.ini file to send T for zero. I haven't even
>>been able to find the [Cut-Number] section in the .ini file.
>>
>>Help? Anyone!
>>
>>73,
>>Ed WB8TSD
>>_______________________________________________
>>WriteLog mailing list
>>WriteLog@contesting.com
>>http://lists.contesting.com/mailman/listinfo/writelog
>>WriteLog on the web: http://www.writelog.com/
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|