Ahah! I did that and got an error message. I will follow up on that this
morning...
Thanks!
Chuck W5PR
----- Original Message -----
From: "Jim Iori" <NU4Y@comcast.net>
To: "Chuck" <w5pr@swbell.net>
Cc: <writelog@contesting.com>
Sent: Friday, December 09, 2011 8:04 AM
Subject: Re: [WriteLog] RigExpert TI-5 Audio Setup Problem with IC-756ProIII
Windows Vista Home Premium
> Try:
> Tools
> Sound Board Options
> check: Echo Microphone
>
> Good Luck,
> Jim
>
> Chuck wrote:
>
>>I just got the RigExpert TI-5 and can't figure out how to get audio
>>through it from the mic plugged into the back of the TI-5 to the rig. CW
>>and CAT functions are ok. It will record off the air. The instructions
>>say: "In the sound card software, select the USB Audio Codec sound card."
>>When I go into Control Panel, Hardware and Sound, Sound I have a record
>>and playback buttons which both show USB Audio CODEC working. I have set
>>the Writelog sound manager to USB Codec. I get no audio from the mic to
>>the rig. I am hoping to make this work with Writelog as a DVK. What am I
>>missing? I don't have to use the foot switch, do I?
>>Thanks!
>>Chuck W5PR _______________________________________________
>>WriteLog mailing list
>>WriteLog@contesting.com
>>http://lists.contesting.com/mailman/listinfo/writelog
>>WriteLog on the web: http://www.writelog.com/
>>
>>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|