Ok, this worked for me! In CQ mode those answering my CQ were going correctly,
but those that I selected from the left pane were not until I made this below
change. Thanks!
Jim/KC4HW
----- Original Message -----
From: Alan Maenchen <ad6e@arrl.net>
To: WriteLog Reflector <writelog@contesting.com>
Sent: 9/2/2019 5:08:43 PM
Subject: [WriteLog] GridSq + S/N ??
________________________________________________________________________________
Don AA5AU wrote:
Jeff, if you are going to use DigiRite outside of contests then you need to
change the exchange in Settings to "Grid Square & db Report". That way
everything flows better and you don't have to use Alternate messages.
My newbie question: Given that there are fixed cycle times of 7.5 or 15
seconds, what's the disadvantage of sending both grid square and signal
report vs just the grid square? It's the same cycle time either way. Every
packet has 75 user bits regardless of what they mean.
I was getting a number of non-contest QSOs and considered (but didn't)
changing to send both all the time instead of just grid square.
Tks & 73, Alan AD6E
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|