That is the acceptable way of doing it Lane since then if the HV fails
the screen supply goes away also. Using a seperate screen supply without
full protection circuitry is asking for trouble.
The 4-1000A is rugged but not indestructable.
73....Carl KM1H
On Thu, 17 Jul 1997 23:54:10 -0700 "Lane C. Zeitler" <km3g@cts.com>
writes:
>Has anyone tried tapping off of the B+ via a dropping resistor to
>provide
>screen voltage to a tetrode?
>
>If you only need a 100ma or less wouldn't this work?
>
>With acceptable E regulation?
>
>Any comments would be appreciated.
>
>Lane KM3G
>km3g@cts.com
>
>--
>FAQ on WWW: http://www.contesting.com/ampfaq.html
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|