Amps
[Top] [All Lists]

[AMPS] screen voltage supply

To: <amps@contesting.com>
Subject: [AMPS] screen voltage supply
From: measures@vc.net (Rich Measures)
Date: Fri, 18 Jul 97 06:10:02 -0700
>Has anyone tried tapping off of the B+ via a dropping resistor to provide
>screen voltage to a tetrode? 

Sure.  A dropping R and a zener string shunt screen-regulator is 
preferred for smallish AB1 amplifiers with minimal screen current 
requirements.  

>If you only need a 100ma or less wouldn't this work? >With acceptable E 
regulation?

Yes.  However, if the anode supply was 9kV no-load (typical 8171), there 
would be 900w of regulator circuit dissipation during receive. That's why 
larger Class AB1 amplifiers usually use a series pass screen-regulator 
with a c.20mA bleeder to handle reverse screen current instead of a zener 
shunt regulator.  
Rich---

R. L. Measures, 805-386-3734, AG6K   


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>