Buddy,
If I remember correctly, the HA-10 uses 4 811A's in parallel. I
had one about ten years ago. Worked okay for SSB service, but I had
to watch the drive level from my T4XC, otherwise lotsa splatter.
Never had it on a scope, so not sure what the IMD was like.
73 de Mike, W4EF/6.............
----------
From: Buddy Lumpkin[SMTP:buddyl@wa.net]
Sent: Sunday, May 11, 1997 10:34 PM
To: Jon Ogden
Cc: Lane C. Zeitler; amps@contesting.com; boatanchors@theporch.com
Subject: Re: [AMPS] Why class B??
Hmmmmmm,
I am not familiar with the Heathkit HA-10 Warrior but I would like to add
that if it is using two tubes in Push-Pull class B is exactly how you would like
them to be biased. Then one tube creates one half of the cycle while the othere
takes care of the other half.
-- Buddy
Jon Ogden wrote:
> >Looking at my old Heathkit HA-10 Warrior I see that the designers set it up
> >to be biased for Class B operation.
> >
> >What are the pros and cons of running class B vice g.g.??
>
> Well, Lane, do you mean class B grid driven?
>
> There are advantages to running grid driven vs. cathode driven (g.g.).
> The grid driven configuration gives quite a bit more gain. Of course the
> down side is that stability is harder to achieve and one has to have a
> negative bias supply.
>
> Class B operation as others have pointed out is when the tube only
> conducts for 180 degrees of the input cycle (or half). The advantage to
> class B vs. A is that it is far more efficient. The advantage over C is
> that it is far more linear. The difference between class AB and B is not
> all the different. AB produces a slightly cleaner signal at the expense
> of less efficiency. Generally, class B is probably sufficient for SSB as
> long as you don't overdrive it very hard.
>
> 73,
>
> Jon
> KE9NA
>
> -------------------------------------
> Jon Ogden
> KE9NA
>
> http://www.qsl.net/ke9na
>
> "A life lived in fear is a life half lived."
>
> --
> FAQ on WWW: http://www.contesting.com/ampfaq.html
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
> --
> FAQ on WWW: http://www.contesting.com/ampfaq.html
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|