On Thu, 21 Jan 1999 06:19:41 PST "Bill Murphy" <zuluhe@hotmail.com>
writes:
>
>Just a aquired a surplus 4cx5000 rf deck and power supply which is odd
>
>ball volts and frequency, looks a like a aircraft amp.
>I need to build a 7500 volts 2 amp pwr supply. What is the most
>suitable
>approach? Where do you get 30000 volt 2 amp diodes, and is a C filter
>
>suitable with this size power supply? Also what minimum C should be
>used
>and what roughly would the secondary volts be? Also for regulation
>what
>is the maximum volts that can be no load applied to this particular
>tube?
>
>Bill
>
I would start with the ARRL or W6SAI Handbook and get a knowledge of
basics first. Then get a full Eimac spec sheet ( I can mail you one for
an SASE).
This is not a beginner project .
73 Carl KM1H
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|