Looking for some wisdom... Need to mount a couple of Jennings CVCJ type
vacuum variables and have never seen a close-up view of the proper way to
physically mount them. My current thinking is to make some brackets out of
1/4" or 1/2" thick aluminum which would clamp to the silver plated areas at
the "front" (shaft end) and the smaller diameter ring at the "back".
Question: Can these areas handle some clamping pressure?
Thanks! 73, Bill N2BC
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|