Amps
[Top] [All Lists]

[AMPS] go figure/Murata mm vs 1/4- 20 threads

To: <amps@contesting.com>
Subject: [AMPS] go figure/Murata mm vs 1/4- 20 threads
From: zellmer@raccoon.com (Jim Zellmer)
Date: Tue, 29 Jun 1999 17:50:32 -0500
If the threads in the Murata caps are metric and the 1/4 20 fit, you
probably snuck by with a length of thread connection.  A 2mm pitch metric
thread has a lead of about .052" per revolution.  vs. about .050" per
revolution for the 1/4-20 thread.  You can get about 3, may 4 turns before
things bindup because of thread interference caused by the differnce in the
lead of the metric and UN thread.

73,

Jim Zellmer, KA0VSL
-----Original Message-----
From: Jon Ogden <jono@enteract.com>
To: Phil Clements <philk5pc@tyler.net>; Rich Measures <measures@vc.net>;
igor rosky <irosky@yahoo.com>; amps@contesting.com <amps@contesting.com>
To: <amps@contesting.com>
Date: Tuesday, June 29, 1999 1:56 PM
Subject: Re: [AMPS] go figure/Murata


>
>>BTW, the threads on the Muratas are metric! Do not try to
>>force  1/4X20 bolts into them!
>
>Mine worked fine.  Standard 1/4" bolts worked well.
>
>73,
>
>Jon
>KE9NA
>
>
>--------------------------------------------------------------------------
>The Second Amendment is NOT about duck hunting!
>
>
>Jon Ogden
>
>jono@enteract.com
>www.qsl.net/ke9na
>
>"A life lived in fear is a life half lived."
>
>
>--
>FAQ on WWW:               http://www.contesting.com/ampfaq.html
>Submissions:              amps@contesting.com
>Administrative requests:  amps-REQUEST@contesting.com
>Problems:                 owner-amps@contesting.com
>Search:                   http://www.contesting.com/km9p/search.htm


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>
  • [AMPS] go figure/Murata mm vs 1/4- 20 threads, Jim Zellmer <=