Hi there.
I have a TL922 by Kenwood and the folowing happend to it:
On Standby-Mode (after some minutes operation) I heard
a loud "bang" . As I looked on the panel the IP-Meter was
showing 500mA. Remember the Amp is set to STANDBY
not to operate nor the PTT is hit.
My guess was maybe a missreading so I pushed the PTT
and sended out a short burst via mike. The Power meter
showed that the AMP is delivering about 1000 watts as
normal. Back to standby - the IP reading is still 500mA.
I turned the thing off.
Any Ideas what happend ?
Anyone had a simular problem in the past ?
I am also seeking for a Service Manual to
download or faxpoll.
Thanks for any help !!!
73sss
Helmut (DF7ZS)
____________________________________________
<A>bort, <R>etry or <I>nfluence with larger hammer !
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|