See if your dentist will let you use a small separating disk in his low
speed handpiece.
Steve W4IMF
----- Original Message -----
From: "Peter Chadwick" <Peter_Chadwick@mitel.com>
To: "'Steve'" <ve3tu@rac.ca>
Cc: "'amps'" <amps@contesting.com>
Sent: Monday, October 09, 2000 8:59 AM
Subject: RE: [AMPS] Bird meters
>
> Steve says:
>
> >Put a rod or another piece of tube inside the 1/8
> >tube and clamp it in a vise length wise
>
> It's rod, not tube. But what is Dremel tool? Don't believe we have them
here - I
> don't remember seeing them in the tool catalogues. Hacksawing the rod is
the
> problem - my hand sawing isn't that accurate.
>
> Must order a new slitting saw - they're circular, and fit the vertical
mill -
> and cost about $15 - and are fairly fragile.
>
> 73
>
> Peter G3RZP
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/amps
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|