>> The lack of sufficient inductance in the filament choke caused the tube to
>> dissipate too much heat in the anode even when at idle.
Could someone explain how this can be so?
Or perhaps the choke is supposed to be a series impedance at 60Hz, keeping the
filament current and thus the emission, down?
(No, I'm not serious!)
73
Peter G3RZP
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|