Amps
[Top] [All Lists]

[AMPS] 240VAC Amplifier Wiring

To: <amps@contesting.com>
Subject: [AMPS] 240VAC Amplifier Wiring
From: Ian White, G3SEK" <g3sek@ifwtech.com (Ian White, G3SEK)
Date: Wed, 15 Nov 2000 15:53:50 +0000
Peter Chadwick wrote:
>
>Rich says:
>
>>It is potentially dangerous not to connect the cabinet of U. S. built 
>>amplifiers to the Neutral wire. 
>
>Do you really mean this, Rich?
>
>I would have thought it should read 'to the ground wire'.
>
>My preference is to run the neutral to the equipment if needed (i.e.for 120volt
>stuff) and the ground wire to the case. That means that major voltage drop in
>the neutral doesn't lift the cabinet above the bonding point potential at the
>supply inlet.
>
>It shouldn't be necessary to say that all this discussion probably doesn't 
>apply
>in places that use different AC distribution systems to those in the US. (like
>Europe and I believe, VK, VU, ZL and ZS)

Wherever there are separate neutral and ground conductors, I think the
"neutral is only for power, ground is only for grounding" principle does
apply.

73 from Ian G3SEK          Editor, 'The VHF/UHF DX Book'
                          'In Practice' columnist for RadCom (RSGB)
                           http://www.ifwtech.com/g3sek

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>