What is the anode voltage in the CW and SSB positions?
These numbers seem about right for a c. 2500VDC anode
supply (SSB position), but would be somewhat low for
a c. 3500 VDC anode supply.
Mike, W4EF...........
----- Original Message -----
From: "Mike Wapner" <MWapner@vetronix.com>
To: <amps@contesting.com>
Sent: Saturday, March 16, 2002 1:08 PM
Subject: [Amps] Henry 3K-A
> I have the opportunity to purchase a Henry 3K-A. The following grid and
> plate currents and power out were measured. Can anyone tell me if these
are
> "normal" or nominal and if the tubes (3-500Z's) appear OK based on this
> info? Thanks for any info!
> 73, Mike-K6QD
> GRID CURRENT PLATE CURRENT POWER OUT
>
> 40 meters CW 260 800 1000+
>
> SSB 200 800 1200+
>
> 20 meters CW 250 800 860
>
> SSB 210 850 1000+
>
> 15 meters CW 260 810 800+
>
> SSB 220 800 1100+
>
> 10 meters CW 250 820 800+
>
> SSB 260 900 1000+
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
|