Very good question , Steve !! I'll take a look at that situation a little
later today.. I'll run the same test with the tube "standing up" as in the
correct position !!!
carl / kz5ca
----- Original Message -----
From: "Steve Thompson" <g8gsq@qsl.net>
To: "'Amps'" <amps@contesting.com>
Sent: Friday, August 02, 2002 1:47 AM
Subject: Re: [Amps] al80a
>
> -----Original Message-----
> From: carl seyersdahl <carlseye@tampabay.rr.com>
> To: 'Amps' <amps@contesting.com>
To: <amps@contesting.com>
> Date: 01 August 2002 23:46
> Subject: [Amps] al80a
>
>
> > In my FWIW dept. I looked over the entire amp and didn't find anything
of
> >conncern. I did find a burned resistor which turned out to be in the
> >external 12vdc line. , but no burned bandswitch contacts, no evidence of
> >anything unusual, but still I knew something was wrong.
> > I tried something interesting , tho, I took the tube out and laid it on
> the
> >bench and hooked up the filament with jumpers , connected the ohmeter
> >between the fil and the grid and when I fired it up, there it was, about
30
> >ohms between the two terminals
> A genuine question on my part, not meant to appear critical of Carl in any
> way.
>
> You described the tube as 'laid' on the bench - if this is on its side
> rather than standing up, will the filament sag and short when it is
powered
> up regardless?
>
> Steve
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|